Processing chemicals should be handled in accordance with the precautions indicated on the boxes and labels of the respective chemicals.
*Always wear protective gloves and safety goggles when handling chemicals with the above indications. This is recommended even for chemicals without these indications. For greater protection, the use of a protective mask and apron is also recommended.
*Wash hands thoroughly after handling processing chemicals or solutions.
* Any spilled chemicals should be wiped up immediately.
*Use caution when mixing chemicals as certain mixtures may produce toxic gases.
*If you get any chemical on your skin or in your eyes, immediately flush the affected part with a great amount of water.
* If you swallow any chemical or get any in your eyes, seek medical attention immediately and show the physician the information printed on the box or label of the chemical(s) involved.
* In some countries, chemicals carrying a poison label ” are required by law to be stored under lock and key. You are responsible for ascertaining and complying with the regulations that apply in your country concerning the handling of poisonous substances.
*Store chemicals in a safe place out of reach of children.
*Waste solutions should be disposed of in accordance with the ordinances governing the handling of industrial waste products in your locale. The P1-R chemical in the CP-48S replenisher cartridge and the Component A of the P1 start-up chemical fall into the category of industrial waste. Should you have any questions concerning these chemicals, consult your service representative.
Special note should be taken regarding the following properties of the CP-48S chemicals.
*The P1-R chemical of the Replenisher Cartridge PC and Component A of the P1 Start-up Chemical These components contain P-phenylenediamine and may thus cause skin and eye irritation if improperly handled. They may be injurious to the health if swallowed.
* The P2-RA Chemical of the Replenisher Cartridge PC and Component A of the P2 Start-up Chemical These components cause oxidation of metals. They may produce harmful ammonia gas if mixed with a chlorine-based bleach (hypochlorite) or an alkaline (P1-R or N1-RA).
* The P2-RB Chemical of the Replenisher Cartridge PC and Component B of the P2 Start-up Chemical
These components may produce harmful ammonia gas if mixed with a chlorine-based bleach (hypochlorite) or an alkaline (P1-R or N1-RA). They may also produce harmful sulfur trioxide gas if mixed with an acid.
*FSC100 (Fuji Super Conditioner) This component contains dichloroisocyanurate and may thus produce harmful chlorine gas if mixed with an acid. It is injurious to the health if swallowed.